Why Company would like to outsourcing their PCB layout, design job?

Outsource can be define as the strategic to use of outside resource,  to preform a more efficient performance. Deciding to outsourcing a PCB design can be easy. We suggest process stages as below.

Initial Design Review :  discuss with your PCB designer and your design engineer regarding the requirement and specification.

Mechanical Review : Mechanical definition of the board before any parts are installed, and creation of the board outline.  Including the tool hole, break-away panel, fiducial mark, and  your products dimension, mechanical drawings of the enclosure to the PCB layout engineer to make sure your requirement are met. more information, please check PCB Design Guide Line

 Components Placement and Review: a poor design can caused your assembly labor higher, failed rate higher,

We can generate the Netlist file from your hand drawing circuit or OrCAD/Protel schematic capture files and layout the board.

reverse engineering service up to 12 layers and over 3000+ Nets. Reverse engineer hardware, firmware, software, mechanical, and other aspects of obsolete products. However, we use very strict guidelines in determining whether a client has rights to reverse engineer any product they forward to us for this service.
Generally, most of our reverse engineering requests come from obsolescence of already existing corporate electronics without documentation.
Some of our reverse engineering requests results in modernization of very old, obsolete, non-documented electronics.

To start PCB layout, simply send an email directly to steve@acme-pcbassembly.com with your netlist files, schematic capture files, and other specific information. We will respond and send our quotation back very shortly.